An Arduino or ESP8266 based weather station which can be extended by different modules.
Go to file
Gergely Polonkai f69efbd224
[Bugfix] Make BMP180 sensor code work
The variable name was wrong, and Wire wasn’t initialized when the sensor was enabled.
2021-02-01 15:32:49 +01:00
.gitignore Initial version that does nothing but replies to the /metrics endpoint 2021-01-15 10:12:14 +01:00
config.h.sample [Bugfix] Fix a constant name in config.h.sample and add a note about MODE_PROM_PUSH 2021-02-01 15:32:49 +01:00
consts.h [Bugfix] Fix a constant name in config.h.sample and add a note about MODE_PROM_PUSH 2021-02-01 15:32:49 +01:00
LICENSE Update the README, and add a LICENSE file 2021-01-15 12:36:19 +01:00
mode_pull.cpp Move the HTTP server code to a new mode_pull module 2021-01-29 11:01:07 +01:00
mode_pull.h Move the HTTP server code to a new mode_pull module 2021-01-29 11:01:07 +01:00
README.md Update the README, and add a LICENSE file 2021-01-15 12:36:19 +01:00
WeatherStation.ino [Bugfix] Make BMP180 sensor code work 2021-02-01 15:32:49 +01:00

Modular Weather Station

An ESP8266 based weather station, designed to be modular.

Hardware requirements

This station is based on ESP8266 boards, like the NodeMCU. I personally develop using a LoLin mini, but also tested the station with an Arduino UNO and a NodeMCU v3 board.

Temperature and humidity

To measure temperature and humidity, you will need a DHT11 or DHT22 sensor. DHT11, usually blue in color, is for indoor usage since its not reliable under freezing temperature, while DHT22, usually white in color, can be used outside.

Atmospheric pressure

To measure pressure, you will need a BMP085 or BMP180 module, connected to the main board via I²C. The sensor on it is also capable of measuring temperature, so if you dont have a DHT11/DHT22 at hand, you can still get temperature data (the firmware prefers DHT11/DHT22 if present).

Ambient light

To measure ambient light level, you will need a BH1750 module, connected to the board via I²C.

Rain

To check if its raining or not, you will need a FC-37 or YL-83 module. Since the only analogue pin of the board is reserved for checking the battery level, you have to use the digital pin of the module.

Power source

If you can put the whole box near an outlet plug, you are good to go! Just attach an old USB phone charger to the board, and your station is powered.

If thats not an option for you, you can attach a battery to the VIN and GND pins. Consult your boards manual for the voltage range.

Compiling

Copy the file config.h.sample to config.h and edit the parameters within.

You can either compile the whole sketch from within the Arduino IDE or, if you are familiar with the command line, you can use the official Arduino CLI tools:

arduino-cli compile -b --fqbn esp8266:esp8266:nodemcuv2 /path/to/the/sketch /path/to/the/sketch/build